Belt Loop Mounting Kit
The Belt loop mounting kit consists of (2) Footman Loops; (4) 1/4" x 20 x 1" SS FHCS bolts; (4) Nylok Nuts
2" Thick Seat Pad
The Sky Ski Seat pad is large, soft and comfortable, comes with non-skid surface to keep you from sliding around too. * High Density, closed cell EVA * 8" x 12" surface * 2" thick * less than 1/2 lb * Tailbone cut-out * Peel-n-stick backing
LE Shock Tower Seat Belt Swivels
The Limited Edition Seat Belt Swivel kit includes 2x belt loops, 2x swivel mounts w/ nylon bushing, 2x 5/16" x 18 x 1.5"bolts & 2x 5/16" nylok jamnuts.
Seat Tower upgrade kit
The Tower upgrade kit consists of: (2) 3/8" x 16 Ratcheting Handles; (2) 3/8" x 16 Shoulder bolts; (2) 3/8" 16 Acorn Nuts, (4) 3/8" SS Flat Washers; (1) Black Urethane Deck Seal. This kit can be used with any seat tower, and is needed when upgrading any older cast foil to a new billet foil.
Pro ST Seat Belt Swivels
The Pro ST Seat Belt Swivels, made specifically for the standard Shock Tower made between 2004 & 2009. These model Shock Towers have a side brace on each side of the underside swingarm that the swivel set bolts to. This swivel kit includes 2x belt loops, 2x swivel mounts w/ nylon sleeve, 2x aluminum spacer, 2x 5/16" x 18 x 1.5" FHCS SS bolts & 2x 5/16" jamnuts.
Pro SS Seat Belt Swivels
These are the standard seat belt swivels with mounting bracket. The mounting brackets bolt to your seat tower in place of the footman loops using the same 4 bolts that previously held the footman loops on and has 3 locations to mount the swivels on them. This swivel kit includes 2x belt loops, 2x swivel mounts w/ nylon bushing, 2x mounting bracket, 2 5/16" x .25" FHCS SS bolts. This swivel set will also bolt up to an older plastic air chair seat tower without modification, and a newer aluminum air chair seat tower with slight modification. Bracket mounting bolts not included, must be purchased separately if needed.
Evolution Tower HD Hinge Replacement Kit
The Evolution Tower heavy duty hinge replacement kit. This kit will replace the original, lighter duty hinges on all Evolution Seat Towers. Each kit consists of: 2x Hinges; 4x Hinge Ends; 4x Clevis pins; 8x washers; 4x E-Clips; 2x Bushings